Complete Setup, One Price: Flagpole + American flag + solar light bundled to save. Shop the Patriot Bundle →

    20 ft · Telescoping

    20 ft TelescopingFlagpole

    The easiest tall flagpole a homeowner can install. No ropes, no tangles, no contractor — just a PVC sleeve set in concrete and a pole that slides in.

    DIY Install Guide

    Install a 20 ft Telescoping Flagpole in an Afternoon

    Four steps, one bag of concrete mix, one weekend afternoon. No welding, no crane, no second person required.

    1. 1

      Dig the sleeve hole

      Auger or hand-dig a hole roughly 24 inches deep and 10–12 inches wide at the mounting location. Confirm you're past frost line for your zone (most of the Midwest is fine at 24"; check your local code).

    2. 2

      Set the PVC ground sleeve in concrete

      Drop in the included PVC ground sleeve, plumb it in both directions, and pour concrete around the sleeve — not into it. Concrete volume depends on the hole you dug; a bagged mix works fine. Let it cure 24 hours before loading.

    3. 3

      Slide the pole into the sleeve

      The collapsed pole slides straight into the cured sleeve — no bolts, no anchors. The sleeve does the structural work; the pole floats inside it so you can lift it out for storms or storage.

    4. 4

      Extend, lock, and fly

      Extend each section, twist the lock collar (hand-tight only — no wrenches), attach the flag to the two swivel rings, and raise. First-time install runs about 30 minutes once the concrete has cured.

    Total hands-on time: about 30 minutes on install day, plus 24 hours of concrete cure between step 2 and step 3.

    Is the 20 ft the Right Size for You?

    Choose 20 ft if you have…

    • • A ranch or single-story home
    • • A smaller front yard or side lot
    • • Low tree canopy on the property line
    • • Plans to fly a 3×5 ft flag
    • • A renter's mindset — might move in 5 years

    Consider 25 ft instead if you have…

    • • A two-story home with a tall roofline
    • • Large mature trees near the install spot
    • • A quarter-acre or larger lot
    • • Plans to fly a 4×6 ft flag
    • • A visibility goal — flag readable from the street
    See the 25 ft page

    20 ft Titan Specifications

    The technical build.

    Extended Height20 ft above grade
    Sections4 telescoping sections
    Butt Diameter3 inches
    Recommended Flag3×5 ft (US flag)
    Wind RatingUp to 95 mph, collapsible in storms
    Collapsed Height~6 ft (fits in an SUV)
    Material6063-T6 American aluminum
    WarrantyLimited Lifetime on shaft

    30-Minute Install

    After 24-hour concrete cure

    Lifetime Warranty

    On the aluminum shaft

    Made in USA

    6063-T6 American aluminum

    Ready to Fly the Flag?

    The 20 ft Titan ships free to the lower 48 with the pole, flag, ornament, hardware, and PVC ground sleeve — everything you need in one box.

    Order the 20 ft Kit